Warp threads should he centered on the loom and parallel to each otherĮasy to assemble, includes instructions, portable design, includes needle, threader, and pouchĪdjustable length, metal construction, includes needle, thread, and instructionsĪdjustable length, durable frame, precise tension control, includes needle and instructions This technique may not work on large pieces or if you have speared a lot of warp threads while weaving. When this happens, place the piece on a flat surface and pet it and roll the beads to help the warp threads move around and relieve the tension. If you do end up with warp threads stretched too tight the piece will bunch up when you cut it loose from the loom. On the other hand, they should not sag like Aunt Martha's clothesline. If you can play the strings like a violin, they are probably too tight. The warp threads should be tight, but not too tight. Keep the tension on all the threads the same. The spacing does not have to be exact, and slightly wide spacing is better than narrow spacing. Press the beads up between the warp threads to see how they fit and adjust accordingly. To check the warp thread spacing for the beads you are using, put ten warp threads on the loom and then put nine beads on a needle and hold them under the warp threads. You can vary the thread spacing to match the beads do this by skipping some coils or by placing two warp threads in some coils. The spacing of the warp threads in the coils of the spacing spring will depend on the width of the beads you are using. Use a simple overhand loop knot to tie warp thread to the screw at one end of the loom It is not necessary to follow any set pattern when adding threads, but the warps should stay centered on the loom and parallel to each other. Repeat until you have the required number of warps on the loom. Go around the screw and return, using the slot next to the one used first. Holding the warp thread taut, but without stretching it, go over and between two corresponding center coils of the spacing spring at the other end of the loom. Starting at approximately the center of the loom, string the warp thread over and between two coils of the spacing spring. Using a simple overhand loop knot, tie off the warp thread to the screw at one end of the loom. If the project ends in a one-bead point, there must be an even number of warp threads to accommodate an odd number of beads. You will always need one more warp thread than the number of beads wide the project is-one bead is placed between each pair of warp threads. Then we'll get to the nitty-gritty of designing and planning a project and having some fun. It is also important to change your eye focus periodically by stopping and looking at something far away and letting your eyes refocus to normal. Do not try to work for long periods without a break. If you are experiencing back pain or muscle strain while working, you need to change something. A comfortable and supportive chair and a table of the right height are essential. It is important to have comfortable working conditions. In this article I'll give you the basic techniques of warping, weaving, and finishing.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |